TRIGGER SHOE: Polymer with OEM straight safety

GEN/CALIBER: Gen 4/9mm (complete drop-in)

CONNECTOR: Enhanced Minus (defined wall/crisp break)

**POSSIBLE LONG LEAD TIMES**

This trigger set includes a modified OEM polymer trigger shoe (with or without pre-travel reduction) or a short reach flat faced aluminum trigger shoe with over-travel adjustment, OEM tuned trigger bar, optional OEM housing with trigger spring (gen 1-4 without housing includes increased power trigger spring), reduced power firing pin safety spring, and either our patent pending enhanced minus connector for defined wall/crisp break or our normal minus connector for a non-defined wall/rolling break tuned setup.

The set comes in a either in a complete drop-in configuration or with drop-in ready parts for your gunsmith to install. Installation and safety checks are provided with the kit. Typical installation is 5 to 10 minutes.

Pull weight for this kit is 3.5 pounds as measured at the bottom of the trigger shoe and should be within half a pound. This setup can be configured heavier (half to a full pound) by using combinations of your OEM trigger and safety plunger spring instead of the provided springs. 

The 9mm options listed exclude Glock 43/43x/48.