TRIGGER SHOE: Aluminum (all black)

GEN/CALIBER: Gen 1-3 / 9mm (complete drop-in)

CONNECTOR: Enhanced Minus (non-defined wall/rolling break)

**POSSIBLE LONG LEAD TIMES**

This trigger set includes a modified OEM curved polymer trigger shoe or a short reach flat faced aluminum trigger shoe with over-travel adjustment, OEM tuned trigger bar, optional OEM housing with trigger spring (gen 1-4 without housing includes increased power trigger spring), reduced power firing pin safety spring, and either our patent pending enhanced minus connector for defined wall/crisp break or our normal minus connector for a non-defined wall/rolling break tuned setup.

The set comes in a either in a complete drop-in configuration or with drop-in ready parts for your gunsmith to install. Installation and safety checks are provided with the kit. Typical installation is 5 to 10 minutes. Check out the install and safety check page to get an idea of what to expect. To help with installation and safety checks, we also recommend purchasing our Armorer's Kit for Glocks (select the gen 1-5 compatible armorer's plate). A typical installation usually does not require any adjustments, however, due to wide tolerance variations between guns, occasionally adjustments may be needed or can better optimize performance for a particular gun.  

Pre-travel/take-up travel reduction on the polymer curved shoe is about 50% reduced compared to stock and the aluminum shoe is about 25-30% reduced compared to stock. Including overtravel reduction, the total travel is reduced by close to half compared to a stock trigger with both options.

Pull weight for this kit is 3.5 pounds as measured at the bottom of the trigger shoe and should be within half a pound. This setup can be configured heavier (half to a full pound) by using combinations of your OEM trigger and safety plunger spring instead of the provided springs.