This Grip Panel is designed to replace the picatinny/1913 rail section on one or both sides of your Gen1 or Gen2 B&T GHM9 and GHM45. Our Slim Grip Panels are 3.4mm thick (B&T picatinny rail is 7mm thick) and are profiled to provide great traction in the center before blending out along the edges back into the GHM9/45 upper receiver. We incorporated the straight slot/rib geometry used on the GHM9/45 grip and lower receiver to help give this replacement panel a factory look.

Our grip panels are machined from 6061-T6 aluminum and hard anodized black per MIL-A-8625. Installation is achieved by removing the 2mm hex/allen or Torx T10 screws in your factory rail section (depending on model), replacing that rail section with our Slim Grip Panel, and then re-installing the factory screws. These panels are left and right side specific, and dedicated to the GHM9/45. Please choose from either left, right, or a pair (both sides) in the drop down menu above.

NOTE: These panels are NOT compatible with MLok type B&T handguards/foreends. They are designed specifically to replace the B&T 2-screw type panels.

• Slim Forend Grip Panel for B&T GHM9/45
• Gen1 and Gen2 Compatible
• Replaces Factory Picatinny Rail Section
• Left/Right Side Specific Panels for Perfect Fitment
• Just 3.4mm Thick, Half Thickness of Factory Pic Rail
• Machined Aluminum 6061-T6
• Hard Anodized Black Per MIL-A-8625

Designed and Manufactured completely in USA.

Gunsmith Installation Recommended for All Parts.