The Overwatch Precision DAT is a flat-faced, direct replacement trigger for your Gen1-5 OEM Glock™ or Glcok™ Clone. Each trigger shoe and trigger safety tab is machined in the USA out of 7075-T6 aluminum alloy, and affixed to an NP3 plated or polished trigger bar by 316 stainless steel coil spring pins. The trigger shoe and safety tab are both Type III hard coat anodized to MIL-A-8625 standard. Proper design allows the safety to retract flush when depressed, eliminating the hot spot on your index finger during long strings of fire.

The broad, flat face of the trigger allows a uniquely self-correcting, straight rearward press. Pre-travel has been reduced by as much as 20% (depending on frame tolerances) without compromising firearm safety features resulting in a clean, crisp break, and reduced re-travel and over-travel.

CTI's NP3 plating provides virtually impermeable corrosion resistance and smooth, grit-free operation. The addition of this trigger alone does not change the pull weight but when combined with our competition trigger spring and Overwatch Precision connector you can expect a reduction in trigger pull weight of one half to one full pound. Please note that we do not tune the trigger bar.  

Building a clone?? Go with the OP Bar for an additional .010 striker engagement.